|06-01-2008, 04:29 PM||#1|
almost new Baja SS ..loaded with extras ..many pics.
Remove this ad - become a site supporter!
Well...I hate to this ....but new baby and work really leave me no time for this summer.
The buggy is two weeks old and has only had just over one tank run through it....maybe 1 1/2 at most....I will include left over gas from Hpi oil supplied with kit as evidence.
It runs great..really impressive actually....
Great care has been taken in building and I've been building rc for over 20 years.
Failsafe works great..can shut down engine from radio and also shuts down engine in case of lost signal or low battery.
Front tires have one strip of gorilla tape around tire inside...rears have foams shoo gooed to rim and then one strip of tape around foam and one strip around tire inside...works great ...no ballooning at all.
Front brace is polished aluminum aftermarket...rear brace has been stripped of anodization and polished to match.
Cassis has been covered with 3m clear scratch guard...will include extra.
Spring mod has been done to brake disk.
Lights plug into stock charging jack.
Servo is top of the line ...fast at .15 and 333oz of torque!
Axle extenders work great...no roll overs.
Punisher graphic is removable sticker and I'll obviously remove my name from the rear wing.
Baja SS Kit. $1073
2 sets Black wheel rings (grey included as well...Unused) $60
TGN failsafe and remote motor switch (Kills motor from radio or if signal lost) $65
Outerwear's filter for air and pullstart. $40
DDM billet gas cap $20
Dark soul axle extenders (orange regulars included as well...Unused) $60
Polished aluminum front and rear shock towers. $40
Hitec 5995tg throttle/brake servo. $100
TGN redneck filter $15
3000mah hump pack $50
Amsoil racing oil...unopened $17
paddle tires...unused $40
Light kit $30
2 spare front arms $40
braided fuel line cover $10
This is basically a brand new buggy and well setup with mods.......
Would be more than happy to demonstrate the buggy in action for anyone interested.
I am in Kitchener and do pass through London every other weekend.
Prices listed are a fair and fairly close to actual spent and not jacked up to include shipping etc.
With well over $1600 spent I'd like to start by asking $1300 for it.....FIRM at this point.
I'd also subtract $100 for the package minus the throttle servo....so $1200
Please....please do not ask me about nitro trades...I'm not interested in them.
Also please do not ask me to seperate anything from this package.
Only trade considered will be for a Samsung DLP TV.
Will come with all original parts,box,manual and tools.
Here the pics...and of course i forgot to put a bunch of stuff in.
Included but missing in pics are....Manual, tools, filters (stock and unused redneck), spare arms, black ring locks.
pics here and a link to check out a couple of videos.
|06-13-2008, 05:09 PM||#3|
here is how custom lights that I made work.
They are ultra bright easy lights made by www.dimensionengineering.com and harness made by me.
light kit is soldered and then covered by braided sleeve neatly.
Simply plug into charging jack when you want to use!
Brighter than anything else with less led to get wrecked.
The little hole beside the plug covered by 3m clear is a viewing window for the failsafe/killswitch l.e.d. to let you know hat is going on with it.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|