|03-22-2011, 12:48 PM||#1|
E-Revo Roller - hopped up
Remove this ad - become a site supporter!
This is an e-revo roller I just built up using spares, and some new parts.
Everything is stock except for:
-shocks are the billet aluminum shocks from a revo 3.3 w/ white springs and 35wt
-towerpro mg995 steering servo
-rpm arms and knuckles / axles carriers (true tracks in the back)
-rpm front bumper (blue)
-traxxas red aluminum tie rods
-traxxas red aluminum push rods (rear only - fronts are steel as they are stronger - and more prone to collision)
-proline aluminum steering arm (brand new)
-proline half offset dish wheels, with proline crimefighters (1 run on tires)
-Traxxas aluminum 17mm splined hubs
-Tekno RC - wing mount and white wing
-not sure what the stock is, but this one has a 68t spur / slipper clutch (brand new - as is the motor mount, plate, cover)
This model is now complete and not missing any parts.
The condition is as pictured - quite nice really - a bit dirty. There are some superficial dings on the chassis, and some on the arms - but not really noticeable and don't impede performance. The battery doors could be replaced (4 dollar part - trx5627) if you were ----, and the transmission could have the outer casing replaced (9 dollars - trx3991x) - as it was used in a previous project that required trimming of one of the tabs- it doesn't affect it whatsoever (ie: internals are perfect) - but - again - could be done if you were ----.
Here are some UPDATED photos:
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|