|10-25-2012, 11:27 AM||#1|
I am: kal c
Join Date: Oct 2012
Feedback: 0 / 0%
Total Props: 0
How to trouble shoot problem with KK board
Remove this ad - become a site supporter!
I am not getting a response from my transmitter or KK board and I am not sure where to start in order to narrow down the problem.
Please see attached photo of my electrical/signal setup on the reciever and kk board.
I have done the following:
1) programmed each ESC/Bec individually with Hobbywing programming card.
Brake -off, Cut Off Type -soft, Cut Off Voltage- low, Start Mode-soft, Timing-middle
2) KK board:
AILE three wires to Reciever AILE, signal, power, neutral
ELEV one wire to ELEV, signal
THRO one wire to THRO, signal
RUDD- one wire to RUDD, signal
6 Motors - all signal/grnd wires go from ESC to Signal terminal on KK
- number 4 motor also has hot wire connected
I have tried:
1) Connected an individual Motor and ESC to THRO on Reciever, was able to
run motor, so I would then assume that I have good signal to the Reciever.
2) When all is connected and turn the Transmitter on I get a solid light on the reciever, when I add THROTTLE the motors twitch.
3) ESC and Motors are not hot.
Last edited by Cloudssoclose; 10-25-2012 at 12:16 PM.
|electrical , esc , heli , hexacopter , kk board , problem , receiver , transmitter|
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|KK Multicopter V 5.5e Board + Smart LCD + USB Link Price Cut!!!||FlyBar||FS - Electronics||9||10-08-2012 12:20 PM|
|Kk multicopter hex||rmorhan||FS - Helicopters & MultiRotors||11||09-19-2012 11:56 PM|
|KK Black board||ryan7700||FS - Helicopters & MultiRotors||1||07-18-2012 04:15 PM|
|original RX/E-Board Novus FP or a walkera 4#3B RX/E Board||heli-insane||Wanted - Electronics||0||09-10-2010 01:17 PM|
|Foam board - Sturdy board||Claude Paradis||Electric Flight||15||12-22-2004 01:31 AM|