|12-20-2012, 08:25 PM||#21|
Level 3 Supporter
★ Site Supporter ★
I am: David C
Join Date: Jul 2010
Location: Morewood, ON
Radio of choice:
MC-20 MX-20 X9D+ X12S
# of RCs: 25
Feedback: 72 / 100%
Total Props: 44
Re: Can I cut my ant.
Remove this ad - become a site supporter!
As long as the insulation does not contain anything that may inhibit signal. I don't know of anything off the top of my head but maybe some colored insulation may contain dyes that have something in them.
The only thing that I have seen people say to avoid is wire tinned with solder as the solder has a bit higher resistivity than copper. Just go with plain copper.
MC-20 MX-20 Taranis X9DPlus HORUS
Friends don't let friends fly Spektrum!
Electric flying is pretty much seeing how close to a dead short you can run without setting it on fire.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Do helical cut gears minimize vibration? Any tricks to cut down vibration?||bensidus197217||General RC Heli Discussion||21||10-19-2012 03:45 PM|
|Hands Free Blue Ant!||hammonr||FS - Other RC||1||04-02-2010 03:37 PM|
|jr r600 receiver with deans ant||thriller||FS - Electronics||2||12-20-2008 03:50 PM|
|ant parts for....||imported_Rc Squirt||General RC Car & Truck discussion||0||05-21-2006 07:50 PM|