|05-01-2013, 09:04 AM||#1|
RCC Junior Contributor
I am: Bobby
Join Date: Jun 2011
Location: Thornhill ON
Radio of choice:
JR11x/JRx9503/Futaba 8 UHPS
# of RCs: 6
Feedback: 5 / 100%
Total Props: 1
JR 11X programming question
Remove this ad - become a site supporter!
I just baught a JR 11X and have a question about mix programming.
I upgraded the software to the 11XG model and noticed In the manual a statement saying that a Trim input can be allocated to one of the levers to change numerical values such as a program mix.
What I would like to do is have a min and max values set to one of the lever and be able to change the Mix percentage from the lever - is this possible?
For example mixing Rudder to Elevator for a knife edge - instead of taking of, do a test, land, update and go back I would like to be able to adjust it on the fly.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Jr/dsm jr 11x system AIRPLANE||big sky||FS - Electronics||3||02-26-2013 11:38 AM|
|Jr 11x||pelgar||FS - Electronics||1||10-14-2012 09:24 AM|
|GY 520 and JR 11X question||nitronutz||General RC Heli Discussion||2||06-30-2011 10:05 AM|
|JR 6102 Programming Question||chevelledude13||Electronics||3||03-18-2006 08:30 PM|
|JR computer radio programming question?||Frank Klenk||Electronics||5||08-05-2003 05:31 PM|