|08-22-2013, 08:41 PM||#1|
RCC Supreme Contributor
I am: StewartW
Join Date: Dec 2010
Location: Fort Sakatchewan, Alberta
Radio of choice:
# of RCs: 5
Feedback: 24 / 100%
Total Props: 12
TH1000 Here's a new one!
Remove this ad - become a site supporter!
So I hooked up Rx voltage, RPM Sensor and Flight pack voltage. It's had Rx pack voltage sensor for some time now but never noticed this issue before.
I plugged in the Rx pack to power up the electronics. I recently put in a TT from parts I had sitting around here. Anyway. I go and touch the throttle and the motor wants to fire up. It's running off the Rx pack. If I unplug the Rx Telemetry wire it stops doing it. What's up with that? Any TM1000 users out there?
S what happens when I plug in the Flight pack of 28v. Will it transfer through and burn anything out? If it can draw to the motor it must be able to feed to the motor right?
The motor actually initializes the 2s Rx pack! WTF?
I didn't think it mattered but I had Rx & Flight pack plugged into Temp/volt input. I guess it doesn't work like that. Unplug Rx plug and it works fine.
Rx voltage is displayed anyway through the Rx/Tx bind. So not sure why I though I needed a plug anyway. Guess I got carried away soldering the other night. Lol
Trex 700E V2 DFC upgrade w/Demon 3sx
Trex 600E Pro w/Ar7200bx and KDE 530kv on 12s
Trex 450 Sport V2 w/2010kv Scorpion 6s, Dx7s
Last edited by craneman32; 08-22-2013 at 08:52 PM.
|08-22-2013, 09:08 PM||#2|
RCC Expert Contributor
I am: Don I.
Join Date: Jul 2012
Location: Mississauga, Ont
Radio of choice:
Feedback: 1 / 100%
Total Props: 6
Re: TH1000 Here's a new one!
The TM1000 has three inputs plus the S-Bus connector. Main battery voltage, rpm, and temperature so hooking up to the RX pack may have triggered some internal switching issue. You don't need to plug in your RX battery to the TM1000. Disconnect it. The RX voltage is sensed from the connection from the TM1000 to the main RX via the data connection.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|