|11-09-2013, 10:00 AM||#1|
RCC Master Contributor
I am: Steve W.
Join Date: Feb 2009
Radio of choice:
Futaba MZ, Futaba SZ
Feedback: 41 / 100%
Total Props: 14
Anyone already using dual s-bus receiver setups with any advice?
Remove this ad - become a site supporter!
I have in transit a Powerbox Champion SRS and will run this on hi volt in my 42% Extra. For radio I will be running the 14MZ and using two R62008SB receivers using s-bus, multi channel on the MZ.
This being a new setup for me I have questions like what is the difference between normal and high speed, PowerBox says to set receivers to Normal. Better yet what is normal, what is high speed in reference to? Why normal not high speed?
Also somewhere I read to use the data jumper for s-bus yet the pamphlet with the receivers says to use for programing s-bus servos. Is it used for both?
I am not new to PowerBox, just this setup so anything to guide would be great.
MAAC 37964, IMAA 20680, IMAC 7194
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|