help installing spektrum rx into walkera qrx350 pro - RCCanada - Canada Radio Controlled Hobby Forum
RCCanada - Canada's Radio Control Hobby Forum
Multi Rotor Discussion Tri's, Quad's, Hex'as and more. Discuss anything multi-rotor, including multi-rotor stabilization and FPV setups.

Thread Tools Display Modes
Old 05-30-2014, 03:29 PM   #1
RCC Junior Contributor
I am: David
Join Date: Dec 2012
Radio of choice:
# of RCs: 999

Feedback: 4 / 100%
Posts: 101
Total Props: 2
help installing spektrum rx into walkera qrx350 pro

       Remove this ad - become a site supporter!
i have recieved my qrx350 pro,i have the unit apart,and would like to know if there is a guide or a thread already on installation,setup,wiring,etc for dx8 and spektrum rx?anyhelp would be appreciated
spitfire1 is offline   Quick reply to this message.

Sponsored Links - Subscribe to remove this ad.
Old 06-01-2014, 06:56 AM   #2
★ Site Supporter ★★ Administrator ★
Max's Avatar
I am: Max P.
Join Date: Feb 2007
Location: Aurora, Ontario
Radio of choice:
JR and Spektrum

Feedback: 20 / 100%
Posts: 13,444
Total Props: 149
Re: help installing spektrum rx into walkera qrx350 pro

Its pretty striaght forward. Just follow the walkera manual for
which channel on the walkera flight controller plugs into the spektrum. The fc only needs input for throttle, aileron, elevator, rudder, and control channel;- usually a gear switch. These would be clearly called outin the walkera manual.
Good luck
RC Test Pilot; FPV Instructor, Airplane Instructor; Helicopter Instructor

My Aircraft Albums:

Last Photo added: Dec 15; Warwing Foamy for FPV
Max is offline   Quick reply to this message.
Old 06-18-2014, 10:41 AM   #3
RCC Apprentice
I am: Vadym
Join Date: Feb 2013
Location: Mississauga, ON
Radio of choice:
# of RCs: 10+

Feedback: 3 / 100%
Posts: 83
Total Props: 0
Re: help installing spektrum rx into walkera qrx350 pro

It is not straightforward at all is this case.

Walkera's manual tell nothing about setting up PNF versions -onyl BNF/RTF ones are kinda covered.

The problem is that Walkera FC does not have a GUI allowing RC calibration (at least mine x350 non-Pro).
Without proper mid/endpoints you're unable to even arm FC (as throttle needs to be -100 and rudder to the max right).
Too many quads to list all of them
Vadimus is offline   Quick reply to this message.
Old 06-18-2014, 07:12 PM   #4
RCC Supreme Contributor
I am: Scott R
Join Date: May 2012
Location: VICTORIA
Radio of choice:
# of RCs: 20

Feedback: 0 / 0%
Posts: 2,014
Total Props: 22
Re: help installing spektrum rx into walkera qrx350 pro

so then just plug it in and trim your midpoints until the quad responds correctly.
bcsaltchucker is offline   Quick reply to this message.
Old 08-12-2014, 06:34 PM   #5
RCC Junior Contributor
jacksost's Avatar
I am: Stefan J
Join Date: Jun 2005
Location: Sarnia, Ontario

Feedback: 3 / 100%
Posts: 123
Total Props: 0
Re: help installing spektrum rx into walkera qrx350 pro

Having difficulty with my DX7. Everything seems to be good, except flight mode 3 and 4, no matter what I set them to, only go to AltHold when I set the switches to those modes. I can set flight mode 1,2 5 and 6 to any of the choices and it works. But no matter what I set 3 and 4 to in the setup, they only activate Alt Hold mode. If anyone has any insite, it would be appreciated. If anyone is using a dx7 with their qr x350 pro successfully with mission planner, or if you have found a post regarding proper setup, please let me know.
jacksost is offline   Quick reply to this message.

Quick Reply

Register Now

In order to be able to post messages on the RCCanada - Canada Radio Controlled Hobby Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

Member names may only be composed of alpha-numeric characters. (A-Z and 0-9)

!!ATTENTION ADVERTISERS!! If you intend on advertising anything on this forum, whatsoever, you are required to first contact us here . Additionally, we do NOT allow BUSINESS NAMES unless you are an Authorized Vendor. If you own a business, and want to do sales on this site via posting or private message, you will need to follow the rules. Shops, Stores, Distributors, Group Buys without being authorized will see your account terminated.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Your Name
Your first name and last initial is required if you plan on using the forum.
Which city & province you live in. This is mandatory for classified listings.
Radio of choice?
Which radio is your current favorite to use?
Number of RC Vehicles?
How many boats, cars, planes do you own?


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
vBulletin Message

Thread Tools
Display Modes

Forum Jump

All times are GMT -5. The time now is 12:48 PM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.