[nickblaster]

hi i have a probleme when i try to setup my alieron link ( upper and lower aileron )with link rod and horn when i push the lower aileron up it ok the upper and lower aileron are equal is ok but when i go down it a diffrent story the lower aileron is at like 1/4in down and the upper airleon is fully down i dont know what do do i am using the dubro T-Style Control Horns carbon rod and kwik link can any one help my with that thx

[nickblaster]

here the picture of the set up

[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]

[tallone66]

Geomitrry issue. use the bottom holes in the horn, one closest to the control surface, then make certain they are both lined up on the T/E of the aileron. That should solve the issue. you can cut off the unused portion of the horn

[nickblaster]

thx for the fast reply i am french when you tell `` make certain they are both lined up on the T/E of the aileron do you meen the leading edge of the aileron with the holes in the horn ?

[Flypaper]

To work properly, the pivot pin must be at the trailing edge of both ailerons. You could make them from aircraft plywood. Cut a slot in the trailing edge and insert the ply and glue. I'll see if I can find a pic to give you a better idea. Here you go.

[nickblaster]

hey thx guys i fix the problem i put sum picture of the fix i cut all the wy my hord and put it close to the edge dans everything work good

[IMG][/IMG]hey thx guys i fix the problem i put sum picture of the fix