|07-23-2015, 08:42 PM||#1|
I am: kevin m
Join Date: Aug 2012
Location: mississauga, ontario
Radio of choice:
# of RCs: 5
Feedback: 1 / 100%
Total Props: 0
savage x 4.6 will not stay running
Remove this ad - become a site supporter!
this is my first nitro rc. but I have many electric rc's 1/10 and 1/8.
when I got this truck it ran and tuned it with no problems.
I have less then 1 gallon of fuel through it.
it starts everytime now.
if I pick it up and rev it, it runs and shifts.
when I put it on the ground it struggles to keep running. and always stalls under throttle.
after if dies it wont start unless I give it full throttle , then it starts and idles fine.
all needles start flush.
and if I lean it out, it gets better for about 3/8 of a turn on the high needle.. can't remember the name sorry... then it starts stalling sooner.
I have taken the Carb off took it all apart and cleaned it in a Ziploc with some new nitro fuel, ok way to clean it I hope?
I took the engine out and it still as good compression (turned it by hand and it has a strong pinch at the top)
put a new glow plug in it.
had my friend at a local hobby store try and tune it ( he is the nitro tech there) and he could not tune it.
clutch is not sticking.
new fuel tank and fuel lines
I think something is wrong with the crab.
do you think I an right?
Last edited by Meh; 07-23-2015 at 08:46 PM. Reason: bumped button on lap top
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|