|11-22-2003, 07:06 AM||#1|
I am: Harry K
Join Date: Sep 2003
Location: Dryden, Ontario
Radio of choice:
# of RCs: 13
Feedback: 2 / 100%
Total Props: 0
Remove this ad - become a site supporter!
How is everyone this fine morning.....start the day with a question.
I'm laid up for a couple weeks from knee surgery so you'll see me lots on here.
I have a fox .35 control line that i would like to change to r/c. but the throat of the carb is tapered. anybody got any ideas?
Harry Ketterer MAAC# 68725
Patricia Region Aero Modelers
Work is what you do for the love of it. My work is model-building. A job is what I do so I can afford to do my work. SPADS RULE
|11-22-2003, 07:47 AM||#2|
RCC Supreme Contributor
I am: Andrew Coholic
Join Date: Sep 2002
Location: Timmins, Northern Ontario
Radio of choice:
Feedback: 5 / 100%
Total Props: 1
Sure, send it to me, and I will trade you for a fox 40 RC with muffler ready to run. Seriously, I was going to convert my 40 to control line use anyway!
If you are interested, email me:
Or, if you are set on doing it here is how I converted an old K&B greenhead a number of years ago... hacksaw off most of the carb, but leave the holes where the NV goes through. Buy a carb for an OS 25 FP/LA and drill out the case of the fox to accept it (if it doesnt have enough meat then you have to turn down the neck of the carb a bit) and use the old NV holes to mount with the two carb screws.
Andrew Coholic -MAAC #26287L
1/2A to giant scale, IMAC, SAM, R/C sport, turbine jets, Heli's...
if its got a wing or two and an engine - I like it!
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|