|01-18-2004, 09:46 AM||#1|
I am: Dave M.
Join Date: Nov 2002
Location: Niagara Falls, On
Radio of choice:
Futaba T7C 2.4
# of RCs: 5
Feedback: 6 / 100%
Total Props: 0
Panel Lines On Monokote
Remove this ad - become a site supporter!
This may be a subject covered before but l didn't find
an answer doing a search. l'm looking for suggestions
on applying panel lines etc. to iron on covering.
Drawing with a marker works but doesn't stand up to
fuel very well. I previously used a Lumocolor permanent
marker. Top coating with clear lusterkote doesn't work
either just dissolves it. Any suggestions?
|01-23-2004, 10:35 PM||#2|
RCC Senior Contributor
I am: Wade Z
Join Date: Dec 2002
Location: Scott's Point, NS
Feedback: 0 / 0%
Total Props: 4
There are some markers made for putting panel lines on covering. Not sure if the ink is fuelproof. May be an idea to check with the LHS.
Living dangerously in the Low Fly Zone (seakings overhead !!!!)
Aircraft Maintenence Engineer-Structures apprentice
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|