|03-10-2016, 06:43 AM||#1|
RCC Expert Contributor
I am: Phil E. P
Join Date: Apr 2005
Location: courtice on.
Feedback: 14 / 100%
Total Props: 2
Remove this ad - become a site supporter!
Hello guys, I have an older MT57 bully and found out that there is some play between the crank and the thrust washer (where the pick up magnet is embedded).
I can rotate the washer while holding the shaft about 1/8 of an inch each way, wouldn't that affect the timing?
If there a key in between them that could be worn out? How would you remove the thrust washer.
Any help would be greatly appreciated. Thank you.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|