|03-26-2016, 12:17 PM||#1|
RCC Pro Contributor
I am: Brad M
Join Date: Mar 2007
Location: Lambton Shores Ont. Canada
Feedback: 26 / 100%
Total Props: 5
Balsa USA Stearman
Remove this ad - become a site supporter!
Hey guys been working on this Stearman off and on for too long, Its seem that the wing indecent are not on the drawing and are set up with a jig off the plans . This kit was started when I got it and I did a rebuild on a plane that was never finish. So this jig to set the indecent could be way off. If any one flying one of these aircraft could tell me what they should be or what they are using that be great. What I have right now is fuse level elevator 1 degree positive (glued) top wing is .4 degree positive, bottom wing .6 degree positive would seem to be close, what do you guys think? maddog
|03-26-2016, 08:16 PM||#2|
RCC Master Contributor
I am: Randy
Join Date: Apr 2010
Location: Penticton BC.
Radio of choice:
JR and Spectrum
# of RCs: 4
Feedback: 14 / 100%
Total Props: 9
Re: Balsa USA Stearman
I looked at the instruction book that I got with my plans but it does not mention the incidence.
I can see a tab on the tip on one of the pictures but that's it.
I didn't pull out my drawings but I would suspect the information is on there.
I also did a search on the web and one fellow said that he had 0 incidence on the bottom and top wing.
Last edited by mrrandyman; 03-26-2016 at 08:25 PM.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|