Register Now

Oilman72 · 04-20-2005, 02:39 AM

LOL, finnaly got my tail twitch figured out and yet another stupid thing happened tonight. Tail went out of control and managed to safely land with no destruction. Upon landing noticing the MicroHeli tail pitch slider ball fell off!! Good greif I say, could have been a major disaster if I was actually way up in air or something. Glad it did not crash yes, frustrated by continous issues it seems. I am just starting to finally accelerate my learning and stopped by yet another issue.

Has anyone had Micro Heli TR pitch sliders on their Shogun or T-Rex, Hornet.. and had an issue like this? If so did you JB weld it back on or how did you confidently go about fixing it for long term to prevent ball from coming off sliding pin? Thanks if you can help!!

Attached a pic to show how clean the ball came off.

Oilman72 · 04-25-2005, 12:41 AM

So you all know apparently there were some quality control issues at MH on their TR products for the T-Rex and Shogun. They are sending me a new part, for now I will run the stock plastic grip system. MH products have been making me nervous as I still am not confident or liking the way their gearcase fits on boom. For now that will stay off my helis as wel.

04-20-2005, 02:39 AM	#1
Oilman72 RCC Contributor Join Date: Jan 2005 Location: Manitoba Feedback: 0 / 0% Posts: 271 Total Props: 0	Micro Heli SE tail pitch slider issue Remove this ad - become a site supporter! LOL, finnaly got my tail twitch figured out and yet another stupid thing happened tonight. Tail went out of control and managed to safely land with no destruction. Upon landing noticing the MicroHeli tail pitch slider ball fell off!! Good greif I say, could have been a major disaster if I was actually way up in air or something. Glad it did not crash yes, frustrated by continous issues it seems. I am just starting to finally accelerate my learning and stopped by yet another issue. Has anyone had Micro Heli TR pitch sliders on their Shogun or T-Rex, Hornet.. and had an issue like this? If so did you JB weld it back on or how did you confidently go about fixing it for long term to prevent ball from coming off sliding pin? Thanks if you can help!! Attached a pic to show how clean the ball came off. Attached Thumbnails
	.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-25-2005, 12:41 AM	#2
Oilman72 RCC Contributor Join Date: Jan 2005 Location: Manitoba Feedback: 0 / 0% Posts: 271 Total Props: 0	So you all know apparently there were some quality control issues at MH on their TR products for the T-Rex and Shogun. They are sending me a new part, for now I will run the stock plastic grip system. MH products have been making me nervous as I still am not confident or liking the way their gearcase fits on boom. For now that will stay off my helis as wel.
	.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

vBulletin Message

Cancel Changes

Register Now

Log-in