RCCanada - Canada Radio Controlled Hobby Forum - Reply to Topic
RCCanada - Canada's Radio Control Hobby Forum
Multi Rotor Discussion Tri's, Quad's, Hex'as and more. Discuss anything multi-rotor, including multi-rotor stabilization and FPV setups.

Thread: Phantom 2 servo for camera gets hot Reply to Thread
Title:
  
Message:

Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-11-2019 05:45 PM
howie2
Re: Phantom 2 servo for camera gets hot

Thanks Andrew, I will try that and let you know how. it worked out
07-11-2019 12:23 PM
kush61
Re: Phantom 2 servo for camera gets hot

Did some research, here's a suggestion...

Check the specifications of your servos (e.g. operating frequency) and run P2 Assistant (version 3.4), you can change the output frequency if "Gimbal Switch" is on.
Apparently there were some issues whether this option was available in P2 Assistant.
So... try the thread below.

http://www.phantompilots.com/threads...bal-tab.11034/

Maybe you could access the Naza controller USB port and connect it to computer.

Cheers
Andrew
07-11-2019 09:59 AM
howie2
Phantom 2 servo for camera gets hot

I have a Phantom 2 that I hooked a servo into the naza for camera control from the receiver.The servo wants to get hot and eventually burn up. I have tried different servos, cheap and good quality doesnt make any difference. I am not forcing the servo beyond its travel either direction. Must have something to do with the vpower coming from the naza. I can hook the servo up to a different battery but thats added weight. Any ideas would be greatly appreciated. Thank you.


All times are GMT -5. The time now is 01:19 PM.


vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.