RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

AJCoholic · 07-10-2019, 07:50 PM

If you have a small nipple (like what you see used for a pressure tap on a muffler) you could try and drill/tap the nylon and epoxy or JB weld the nipple.

Ive seen these OS plastic parts repaired with just a short length of K&S brass tubing the same way, drill and place the tubing in the hole and JB weld.

If you aren’t attached to the NV assembly, you can use any NV as a remote - I have a lot of NIP OS needle assemblies that are usually used threaded into a carb body - but they work fine as a remote NV, you just need to mount it somewhere.

07-10-2019, 07:50 PM	#3
AJCoholic RCC Supreme Contributor I am: Andrew Coholic Join Date: Sep 2002 Location: Timmins, Northern Ontario Radio of choice: JR 12X, 28X Feedback: 47 / 100% Posts: 12,277 Total Props: 61	Re: OS LA .25 Fuel Nipple If you have a small nipple (like what you see used for a pressure tap on a muffler) you could try and drill/tap the nylon and epoxy or JB weld the nipple. Ive seen these OS plastic parts repaired with just a short length of K&S brass tubing the same way, drill and place the tubing in the hole and JB weld. If you aren’t attached to the NV assembly, you can use any NV as a remote - I have a lot of NIP OS needle assemblies that are usually used threaded into a carb body - but they work fine as a remote NV, you just need to mount it somewhere. __________________ Andrew Coholic -MAAC #26287L 1/2A to giant scale, IMAC, SAM, R/C sport, turbine jets, Heli's... if its got a wing or two and an engine - I like it!