[Cougar429]

While cleaning my build room one of the things organized was all my heli gear and along with spares there was a project set aside for years.

The title shows the instruction name and little else other than a small blurb on the end to contact CNC Effects. No luck searching online using either listing.

I can see what major components would be needed such as boom, clamp and tail, but not much else is listed. One of the more important would be motor mounting and if this will work with either belt and shaft drive setups. Was hoping to make this FBL.

Anyone familiar with this one?

[Cougar429]

While looking for something else found the lower frame and landing gear. Now just have to locate a tail group, (boom clamp tube, braces and tail assembly, along with a main gear one way bearing.

Was able to contact the original builder for remaining bits.